The short answer
Hard water stains are mostly calcium carbonate left behind when water dries. A mild acid dissolves them. Keep white vinegar or a citric-acid descaler in contact with the stain long enough to work, scrub gently, rinse and dry. Never mix acids with bleach, and keep acids off marble, travertine and limestone, which are calcium carbonate too.
Key takeaways
- Hard water stains are mostly calcium carbonate scale, left when hard water evaporates or is heated (USGS).
- Mild acids dissolve carbonate scale. Rinnai's tankless heater descaling procedure circulates undiluted white vinegar for at least an hour.
- Never mix vinegar or any acid with bleach. Health Canada warns the combination releases toxic gases.
- Acids etch marble, travertine and limestone because those stones are also calcium carbonate. Use a pH-neutral stone cleaner.
- City of Phoenix water measured 10–17.6 gpg (172–302 mg/L) in 2025, so drying wet surfaces is the cheapest way to prevent new stains.
On this page
- What are hard water stains?
- What removes hard water stains best?
- How do you remove hard water stains from faucets and showerheads?
- How do you get hard water stains off a glass shower door?
- How do you remove a hard water ring from a toilet?
- Can you use vinegar on tile, granite or marble?
- What should you never mix with vinegar or descalers?
- How do you keep hard water stains from coming back?
- Will a water softener stop hard water stains?
White crust on the faucet, a chalky haze on the shower door, a gray ring in the toilet: in a Phoenix home, these come back fast. The good news is that the chemistry is simple and the fix is cheap. Below is what works on each surface, what not to put on stone, the one cleaning mistake that can hurt you, and how to keep stains from coming back.
What are hard water stains?
Hard water carries dissolved calcium and magnesium. When a drop of it dries, or when hard water is heated, the minerals come out as solid calcium carbonate, the white, chalky scale the USGS describes building up on fixtures, in plumbing and in water heaters. Thin layers look like spots or haze. Thick layers form a hard crust.
The City of Phoenix’s 2025 Water Quality Report lists hardness of 10–17.6 grains per gallon (gpg), or 172–302 mg/L. Penn State Extension classes anything above 10.5 gpg as “very hard.” If you live elsewhere in the Valley, look up your number on our Phoenix-area water hardness page.
Hardness isn’t a health problem. The City of Phoenix notes that hardness isn’t regulated under drinking water health standards. It’s a cleaning and maintenance problem, and that’s what this page is about.
What removes hard water stains best?
Calcium carbonate dissolves in mild acid. That’s why white vinegar works, and why many commercial descalers are acid-based. It’s also why appliance makers trust it: Rinnai’s tankless water heater manual descales the heat exchanger by circulating 4 gallons of undiluted food-grade white vinegar for at least an hour.
Two things matter more than which acid you pick:
- Contact time. Scale dissolves slowly. A quick spray and wipe barely touches it. Keep the acid on the stain, wet, for a while, then come back and check.
- Keeping it wet on vertical surfaces. Vinegar runs off glass and tile. Soak paper towels or a cloth in it and press them on, or use a thicker gel-type descaler.
Citric acid is a common alternative. We didn’t find authoritative guidance on the right strength, so follow the label of the product you buy.
Here’s a quick guide by surface:
| Surface | What to use | Method | Avoid |
|---|---|---|---|
| Chrome faucets and showerheads | White vinegar or citric descaler | Soak or wrap, then scrub | Abrasive pads; acids on specialty finishes without checking care instructions |
| Faucet aerators | White vinegar | Unscrew and soak | Forcing it with pliers on bare metal (wrap it with a cloth) |
| Glass shower doors | Vinegar or descaler, kept wet | Cling wrap or soaked towels, scrub, squeegee | Scouring powder and steel wool |
| Toilet bowl ring | Vinegar or citric descaler | Lower the water, apply, wait, brush | Any acid in a bowl that still has bleach cleaner in it |
| Glazed ceramic or porcelain tile | Vinegar or descaler | Test a hidden spot, apply, scrub, rinse well | Letting acid sit on grout without rinsing |
| Marble, travertine, limestone | pH-neutral stone cleaner only | Wipe, rinse, dry | Vinegar, lemon, citric acid, acid descalers |
How do you remove hard water stains from faucets and showerheads?
For faucets:
- Wrap the fixture. Soak a cloth or paper towels in white vinegar and wrap them around the stained area so they stay in contact.
- Wait. Give it time. Check after about an hour, which is the contact time Rinnai uses to descale an entire heater, and re-soak heavy crust.
- Scrub gently with a soft brush or old toothbrush, paying attention to the base and around the handles.
- Clean the aerator. Unscrew the tip of the faucet, soak the aerator in white vinegar, brush the screen, rinse and reinstall.
- Rinse and dry the fixture with a soft towel so new drops don’t leave new spots.
For a showerhead you can’t easily remove:
- Fill a plastic bag with enough white vinegar to submerge the nozzles.
- Fasten it around the showerhead with a rubber band or twist tie.
- Leave it for about an hour, longer for heavy buildup, checking as you go.
- Remove the bag, rub flexible rubber nozzles with your thumb to pop scale loose, and run water for a minute to flush.
Clogged showerheads are one of the first things to go in hard water. In testing commissioned by the Water Quality Research Foundation (an industry group), Battelle ran low-flow showerheads on 26 gpg water and all five hard-water units clogged; the softened-water units didn’t.
Some decorative finishes have care instructions that rule out acidic cleaners. If your fixtures aren’t standard chrome, check the manufacturer’s care guide before using any acid.
How do you get hard water stains off a glass shower door?
- Start with dry glass, so the vinegar isn’t diluted.
- Apply and keep it wet. Spray white vinegar or a descaler, then press vinegar-soaked paper towels against the worst areas, or cover them with plastic wrap to slow evaporation.
- Wait for the scale to soften, then check a small area.
- Scrub with a non-scratch pad, working in small sections. Pay attention to the bottom third of the door and the track, where water sits longest.
- Rinse thoroughly with plain water.
- Squeegee and dry. A dry towel finish shows you what’s left.
Repeat for heavy buildup. If the glass is still hazy after the scale is clearly gone, it may be etched, which is damage to the glass itself and can’t be cleaned off. Our dishes and glass page has a simple test for telling film from etching.
How do you remove a hard water ring from a toilet?
- Make sure there’s no bleach in the bowl. If you use a bleach-based bowl cleaner or an in-tank bleach tablet, stop using it, remove the tablet, and flush several times before adding any acid.
- Expose the ring. Turn off the toilet’s supply valve and flush to lower the water level below the ring.
- Apply the acid. Pour or spray white vinegar or a citric-acid descaler onto the ring, or lay vinegar-soaked paper towels over it so it stays wet.
- Wait, then scrub with a toilet brush or non-scratch pad.
- Turn the water back on and flush.
Step 1 is the one people skip. Health Canada warns that bleach reacts with acids, including vinegar, to release toxic gases. A toilet is a small, closed space where products tend to get mixed without anyone noticing.
Can you use vinegar on tile, granite or marble?
Before you start, find out what the surface actually is. Many shower walls, floors and countertops are natural stone, and stone needs a different approach from glazed tile.
Glazed ceramic and porcelain tile
Treat it like glass: apply vinegar or a descaler, keep it wet, scrub with a soft brush, then rinse well and dry. Test a hidden spot first, and rinse grout lines thoroughly so the acid doesn’t sit there.
Marble, travertine, limestone and granite
Not on marble, travertine or limestone. Those stones are made of calcium carbonate, the same mineral as the scale you’re trying to remove, so acids like vinegar, lemon juice and citric acid etch them. The dull spot an acid leaves on marble isn’t a stain; it’s the surface itself dissolving.
Use a pH-neutral cleaner made for natural stone, wipe often, and dry the surface after use. If you’re not sure whether a countertop or shower surround is granite, marble, travertine or a cultured product, treat it as acid-sensitive until you know. For built-up scale on stone, a stone-care professional is the safer call.
What should you never mix with vinegar or descalers?
Acid cleaning is safe when you follow a few rules:
- Never mix acids with bleach. Health Canada warns that bleach reacts with any product containing ammonia or an acid, including vinegar, to form toxic gases. Don’t use them in sequence on the same surface without rinsing thoroughly in between.
- Never mix two cleaning products, even two descalers.
- Ventilate. Run the bath fan or open a window.
- Wear gloves and keep acids away from your eyes. Follow the first-aid instructions on any commercial product’s label.
- Keep products in their original containers, out of reach of kids and pets.
- Rinse surfaces with plain water when you’re done.
How do you keep hard water stains from coming back?
Cleaning removes the scale. Prevention is about not letting hard water dry where you can see it:
- Squeegee or towel shower glass and fixtures after use. It takes under a minute and is the single best free habit.
- Fix drips. A slow drip deposits minerals in the same spot all day.
- Rinse and dry sinks and counters at the end of the day.
- Turn the water heater down if it’s set high. University of Georgia Extension notes that lower temperatures produce less scale, though dishwashers may not clean well below 140 °F.
Phoenix makes this harder than most places. The water is very hard, hot-side fixtures scale fastest because calcium carbonate becomes less soluble as water heats, and drops dry quickly in desert air. Scale also builds inside fixtures and pipes where you can’t wipe it; our hard water and plumbing page covers that side.
Will a water softener stop hard water stains?
It removes the cause. An ion-exchange softener takes out calcium and magnesium and adds a small amount of sodium in their place, so new scale largely stops forming. It won’t clean what’s already there, and it won’t make glass spot-free forever: Phoenix water also carries 464–716 mg/L of total dissolved solids, which can still leave faint marks if drops dry, so a quick squeegee is still worth it.
Salt-free conditioners are a different technology. They change how hardness minerals behave but don’t remove them, so they don’t stop spotting. Our salt-free vs salt-based guide explains the tradeoffs honestly.
If you’re cleaning the same stains every week, our free in-home water test shows your hardness, TDS, chlorine and pH, and you’ll get an upfront written quote if a water softener makes sense. You can book the free test here.
Frequently asked questions
Is a commercial descaler better than vinegar?
Commercial descalers are also acid-based, so they work on the same chemistry. Whichever you use, follow the label for which surfaces it's safe on and how long to leave it, ventilate the room, and never combine it with bleach or with another cleaner.
Is citric acid better than vinegar for hard water stains?
Both are mild acids that dissolve carbonate scale. We found no authoritative guidance on the best citric acid strength, so follow the product label and the care instructions for the surface you're cleaning.
Can hard water stains become permanent?
Old, thick scale can take several rounds to remove, but it's still a deposit. If glass stays cloudy after the scale is gone, the surface is probably etched, and cleaning won't reverse that.
Will a water softener remove existing hard water stains?
Plan on cleaning the existing scale yourself once. A softener's job is to remove the calcium and magnesium that create new stains, so the cleanup lasts much longer afterward.
What is the white crust around my faucet base?
It's calcium carbonate scale that builds up where water sits and evaporates, often from a slow drip or splashing. Clean it with the faucet steps on this page and fix any drip. See our plumbing page for scale inside fixtures and pipes.
Sources
- Hardness of Water. USGS Water Science School. www.usgs.gov/special-topics/water-science-school/science/hardness-wate…
- 2025 Water Quality Report. City of Phoenix Water Services (2025). www.phoenix.gov/waterqualityreport
- Water Softening. Penn State Extension (2025). extension.psu.edu/water-softening
- N-Series Installation and Operation Manual (descaling procedure). Rinnai. media.rinnai.us/salsify_asset/s-0dbc4660-4b6d-4210-82c7-a7ed6834a355/1…
- Reduce your risk of toxic gases: never mix bleach with other cleaning products. Health Canada. recalls-rappels.canada.ca/en/alert-recall/reduce-your-risk-toxic-gases…
- Corrosive or Scaling Water, C858-9. University of Georgia Extension (2026). fieldreport.caes.uga.edu/publications/C858-9/corrosive-or-scaling-wate…
- Battelle Finds Water Softeners Aid Energy Efficiency, Appliance Life (WQRF-funded). Contractor magazine (2010). www.contractormag.com/green/article/20872711/battelle-finds-water-soft…
- WaterSense Technical Reference: Water Softeners. U.S. EPA WaterSense (2023). www.epa.gov/system/files/documents/2023-08/ws-homes-TRM-9-WaterSoftene…
- Salt-Free Water 'Softener' Alternatives. Nebraska Extension (2018). water.unl.edu/article/drinking-water-wells/salt-free-water-softener-al…
This page is general information from a water treatment company, not medical or veterinary advice. Where we cite research we link the original source. Found an error? Email andrew@cactuswatersolution.com and we'll fix it.